Products
Technology
SMS solutions
PBX systems
Databases
Robotics
Building robot hardware
Building electronics
Ozeki Matrix
Arduino
Electronics
PCB designing
Making the board
Drilling and cutting the board
Soldering and testing
Burnishing and soldering
Testing your PCB panel
Building robot software
Company


Burnishing your PCB and soldering components on it

Now comes our electronic engineer's favorite part. The part when they can finally solder the components onto the board and say out laud that the board is ready. You can learn more about burnishing and soldering from the screenshots we have provided for you. After you completed this tutorial only testing remains which you can learn about in the next tutorial.

Start the video

Screenshots below:

Burnish smoothly the surface of the PCB board with a sandpaper
Figure 1 - Burnish smoothly the surface of the PCB board with a sandpaper

Put copper wires through the vias and solder them
Figure 2 - Put wires through the vias and solder them. We advise copper wires.

Solder remaining components onto the board
Figure 3 - Solder remaining components onto the board

The finished PCB board
Figure 4 - The finished PCB board. To test it out, jump to the next tutorial.


Copyright © 2000- - Ozeki Informatics Ltd. | info@ozeki.hu | Tel: +36 1 371 0150
Home > Technology > Robotics > Building electronics > Electronics > Soldering and testing > Burnishing and soldering
Page: 2915