How to connect a Soil moisture sensor to Arduino
Contents
Toolkit
- 1x Arduino Uno
- 1x Soil Moisture Sensor For arduino
- 1x Soil Hygrometer Detection Module
- Wires to connect the sensor to Arduino
Specification
This is a simple water sensor, can be used to detect soil moisture. Module Output is high level when the soil moisture deficit,or output is low. This sensor is inexpensive and easy to use but very accurate so the starters and the experts can use all of it's functions.
Can be used in module plant waterer device, and the plants in your garden no need people to manage. Adjustable sensitivity by adjusting the digital potentiometer.
- Operating voltage: 3.3V~5V
- Dual output mode,analog output more accurate.
- A fixed bolt hole for easy installation
- Panel PCB Dimension: 30mm * 16mm
- Soil Probe Dimension:60mm*30mm
- With power indicator (red) and digital switching output indicator (green)
- Having LM393 comparator chip, stable
PIN Assignment
- VCC : 3,3V to 5V
- GND : External GND
- DO : Digital output interface (0 and 1)
- AO : Analog output interface
- The local circuit - simple, voltage flipping style sensor
Example Code
Arduino Code:
void setup() { // initialize serial communication at 9600 bits per second: Serial.begin(9600); } void loop() { // read the input on analog pin 0: int sensorValue = analogRead(A0); Serial.println(sensorValue); delay(100); }
References
More information
- Anschluss des DHT11-Temperatur- und Feuchtigkeitssensors
- Anschluss eines NFC-Lesegeräts an Arduino
- Anschluss eines Bodenfeuchtigkeitssensors an Arduino
- Anschluss des TMP36-Temperatursensors an Arduino
- Anschluss des US1881-Hall-Sensors an Arduino
- Anschluss eines BMP085-Drucksensors an Arduino
- Anschluss eines TSL2561-Helligkeitssensors an Arduino
- Anschluss eines YL-83-Regen-Sensors an Arduino
- Anschluss eines Modern Device Wind-Sensors an Arduino
- Anschluss eines SI1145-UV-Sensors an Arduino
- Anschluss einer Infrarot-Fernbedienung