Arduino DC Motor Chat Control
DC motors can be controlled by the L298N DC motor driver IC, which is connected to your microcontroller. L298Ns can control up to 2 DC motors. You can easily add motors through the program code. You can set DC motor speed by changing the duty-cycle of each PWM signal. The PWM is a square-wave signal which has two parameters: frequency and duty-cycle. If a PWM signal's duty-cycle is 100% than the motor spins with maximum rpm. In case of 0% the motor will stop. Motor speed and direction in your Ozeki software can be changed on each motor with the motor's own adjustable slide bar from -100% to 100%. If the slide crosses 0 than the motor will change spin direction.
You can chat with the device at the Ozeki 10 as the video shows below.
Possible commands
More information
- Wie man einen Gleichstrommotor am Arduino Mega einrichtet
- Wie man einen Gleichstrommotor am Arduino Nano einrichtet
- Wie man einen Gleichstrommotor an der Ozeki Matrix einrichtet
- Wie man einen Gleichstrommotor am Raspberry Pi einrichtet
- Gleichstrommotor-Protokoll für Arduino
- Wie man einen Gleichstrommotor mit Chat-Nachrichten steuert
- Wie man einen Gleichstrommotor am Arduino Uno einrichtet