Ozeki Matrix Analog Sensor Control Code

Analog Sensors can sense multiple analog signals and convert them to digital numbers with the help of an integrated ADC converter. ADC converters are analog to digital converters. You can learn more about ADC conversion on the internet. You can use or analyze these digital numbers later on. 0 to 5V is represented by numbers from 0 to 1023. You can read multiple sensors by adding multiple analog pins to your programcode.

ozeki analog module
Figure 1 - Ozeki Analog Module

Required hardware

Source code to install on controller

Before you upload this code to your Arduino, please format the EEPROM...

Analog Sensor Arduino

#include <OzIDManager.h>
#include <OzAnalogSensor.h>
				
OzIDManager* manager;
OzAnalogSensor* analogSensor;

void setup() 
{
  Serial.begin(115200);

  manager = new OzIDManager;
  manager->_sendACK = true;
  manager->_checksum = true;

  OzCommunication::setIDManager(manager);

  analogSensor = new OzAnalogSensor(A5);
  analogSensor->reset();

  int x=1;
  manager->sendLinkSetup();
  manager->PrintWelcomeLine(analogSensor, x++, "MyAnalogSensor");
}

void loop()
{
  OzCommunication::communicate();
  analogSensor->ownLoop();
}

More information